Equipment Manuals and Technical Guides
Cannot adjust spray pattern (Loosen nut)
System continuously sprays solution (Loosen Nut)
Needle stuck and will not move (Loosen Nut)
Trigger stuck, no movement, or sticks (Loosen Nut)
Leakage from the Gland Nut (Tighten Nut Carefully)
When adjusting the Gland Nut, do so very carefully, in small 1/16 increments. Do not over tighten, as nut can be damaged or stripped.
Gland Nut Adjustment Sheet (Standard guns, pre 2015): CLICK HERE
Maximist Standard gun, Pro Needle (metal needles only) Removal Guide: CLICK HERE
If only cleaning current needle (not replacing) do not discard any parts. Wipe needle with a soft cloth under warm water, and replace old needle back into gun.
A gun that spits, or splats, or will not spray solution, should be well cleaned, including removal and cleaning of the needle. If problem continues, check needle for damaged or broken tip, or grooves.
Ultra Premier Product Manuals: CLICK HERE
Ultra Pro Product Manuals: CLICK HERE
Maximist Pro Gun Parts Breakdown Sheet: CLICK HERE
Progun Cleaning Guide – CLICK HERE
Maximist Pro Gun Parts Breakdown Sheet: CLICK HERE
Progun Cleaning Guide – CLICK HERE
Maximist TNT and Maximist Pro Product Manual: CLICK HERE
TNT Gun reset (if gun spits or cannot be adjusted see this guide) – CLICK HERE
Maximist Pro Gun Instructions and Parts Breakdown Sheet: CLICK HERE
Progun Cleaning Guide – CLICK HERE
Dial Base Setting on unit (if unit shuts down unexpectedly, see this sheet) – CLICK HERE
Maximist XL and Maximist Pro Product Manual: CLICK HERE
Maximist Pro Gun Parts Breakdown Sheet: CLICK HERE
Progun Cleaning Guide – CLICK HERE
Lite Plus Product Manual: CLICK HERE
Spraymate Product Manual (Standard gun 2014 and earlier): CLICK HERE
Spraymate TNT Product Manual (TNT gun 2015 and later): CLICK HERE
TNT Gun reset to Factory Default (if gun spits, splatters, cannot be correctly adjusted, or for use whenever gun is disassembled to reset): CLICK HERE
Spraymate Pro Product Manual (Pro gun 2015 and later): CLICK HERE
Maximist Pro Gun Parts Breakdown Sheet: CLICK HERE
Progun Cleaning Guide – CLICK HERE
Pro TNT : CLICK HERE
Gun reset to Factory Default (if gun spits, splatters, cannot be correctly adjusted, or for use whenever gun is disassembled to reset): CLICK HERE
Allure Xena Gun or Standard Gun : CLICK HERE
Gun reset to Factory Default (if gun spits, splatters, cannot be correctly adjusted, or for use whenever gun is disassembled to reset): CLICK HERE
Apollo T6000 Parts Diagram: CLICK HERE